Mac address flapping cisco switch

Contents

  1. Related Articles
  2. MAC address Flapping |VMware Communities
  3. What is a MAC Flap?
  4. MAC Address flapping

The process of doing a disable and enable operation on the team interface will cause it to select a new MAC address from the remaining team members. So under normal operations you should not see any flapping occurring. This site uses cookies for analytics, personalized content and ads. By continuing to browse this site, you agree to this use.

Related Articles

Learn more. Office Office Exchange Server.

Not an IT pro? Resources for IT Professionals. Sign in. United States English.

MAC address Flapping |VMware Communities

Ask a question. Quick access. Search related threads.

Remove From My Forums. Answered by:. Windows Server. Windows Server General. Sign in to vote. Tuesday, June 18, AM. Hi, Thank you for the post. You may consult Cisco support to see if there is normal behavior. Friday, June 21, AM. Switch config port-channel load-balance? Highlight both NICs, and the click Team. In the Team Properties window, click Ok , and when the confirmation window appears, click Yes to continue. When prompted to reboot the server, click Yes. Once the server is rebooted, open the network configuration utility in order to verify the teaming status.

Cisco Layer 3 Switch MAC Flood Attack

Right-click My Network Places. An additional network card, Local Area Connection 3, displays in the window. Once the NIC adapters are teamed and a new connection is formed, the individual NIC adapters are disabled and are not accessible through the old IP address. Use the OIT to view an analysis of show command output. The solution was to create the EtherChannel per this configuration example and the errors went away. Solution The Cisco G switch has theses errors in the logs: Jun 30 Recommended action: Check the network switches for misconfigurations that might cause a data-forwarding loop.

A document was found that showed how to setup EtherChannel and Nic Teaming. Design Guidelines: The EtherChannel should start on a single device and end on another single device. Configure the port as a Layer 2 switchport. Connecting hubs, concentrators, switches, bridges, etc Start the NIC configuration utility.

What is a MAC Flap?

HP does not control and is not responsible for information outside of the HP Web site. Provide feedback Please rate the information on this page to help us improve our content.

Thank you! Was the information on this page helpful? Very helpful Somewhat helpful Not helpful.

MAC Address flapping

Please complete the form before submitting. All fields are required. Not helpful. Note: Only English language comments can be accepted at this time. Please wait while we process your request.